- From: pafp AT email.iis.com.br (Pedro Prado)
- Subject: [Lcdproc] Dot Matrix T6963c
- Date: Sat Oct 26 20:19:01 2002
Hi µ-thos,
This is the Interface Signais of my LCD
LCD Pin Number:
1 - FGND ( Frame Ground - Connected to Bezel )
2 - VSS ( Ground Potential - Logic )
3 - VDD ( Power Supply to Logic and LCD )
4 - VEE ( Power Supply to LCD )
5 - WR (Data Write )
6 - RD ( Data Read )
7 - CE ( Chip Enable )
8 - C/D ( Code / Data )
9 - NC ( Non Connection )
10 - Reset ( Controller Reset )
11 - D0 ( Data Bus - LSB )
12 - D1
13 - D2
14 - D3
15 - D4
16 - D5
17 - D6
18 - D7 ( Data Bus - MSB )
19 - FS ( Font Select )
20 - NC ( Non Connection )
[]'s
Pedro Prado
----- Original Message -----
From: "µ-thos"
<mythos AT xmythos.de>
To:
<lcdproc AT lists.omnipotent.net>
Sent: Friday, October 25, 2002 2:09 PM
Subject: Re: [Lcdproc] Dot Matrix T6963c
>
Hi Pedro,
>
>
>
PP> I have a Sharp LM24014-H with Toshiba 6963c Controller. Does This
table
>
PP> of connections function with my LCD?
>
>
>> Parallel: LCD:
>
>> 1 (Strobe) ----------- 5 (WR)
>
>> 2-9 (Data) ----------- 11-18 (Data)
>
>> 14 (Autofeed) -------- 7 (CE)
>
>> 16 (Init) ------------ 8 (C/D)
>
>> 17 (Slct) ------------ 6 (RD)
>
>> 18 (GND) ------------- 3 (GND)
>
>> +5V ------------------ 3(LCD +)
>
>
the PIN number changes from display to display. So I cannot tell you
>
anything about this. You have to check what your PINs are for. So the
>
names of the PINs are important (i.e.: Strobe - WR)
>
To find this out for your display try to get some describtion from the
>
manufacturer.
>
>
cu,
>
µ-thos
>
mailto:mythos AT xmythos.de
>
-------------------------------------------------------
>
Visit me at: www.xmythos.de
>
-------------------------------------------------------
>
>
_______________________________________________
>
LCDproc mailing list
>
LCDproc AT lists.omnipotent.net
>
http://lists.omnipotent.net/mailman/listinfo/lcdproc
>
>
Archive powered by MHonArc 2.6.18.